canon mx430 series printer ws vs canon mx430 series printer

#Canon mx430 series printer ws vs canon mx430 series printer Pc#
#Canon mx430 series printer ws vs canon mx430 series printer free#

Make sure the plastic holding the roller still moves up and down freely, the sponge should not be so tight as it prevents free movement.My MG550 had this issue from new as well but this spong has fixed it. just done 150 double sided sheets with no problems. This increases pressure on the roller so it takes the paper every time. Put the sponge behind the piece of plastic away from the rollers taking care not to put it behind the actual rollers. I noticed there is hardly any force pressing the roller to the paper, hence the problem. You will notice the feeder roller attached to a plastic panel that moves up and down to grip the paper, this roller has a small spring on the side. (its under the printer behind a panel that has the paper in. Now find the paper feeder roller that takes the paper from the tray. Hi Folks, this is an asy fix, get a sponge, I used the sponge off a dish scourer, you only need half of that, cut it off the scourer part. I wanted to avoid removing the tiny tension spring, because they frequently fly off into another dimension, and fortunately I stumbled upon a post by David Camm on a TechAdvisor forum thread:

So I went to the Internet for inspiration because I knew I wanted to somehow either add weight to the horizontal bar on which the rollers were mounted, or increase the spring tension. There's nothing really you can adjust with these printers the tension spring was just not good enough to adequately pull the rollers down into contact with the paper. You end up stretching the rubber tracks around the feed rollers, wearing them smooth prematurely and ending up with catastrophic loss of grip, just like excessive camber on F1 cars (ha). I tried all sorts - wrapping the rollers with small strips of tacky gaffertape to widen their diameter, pushing up on the underside of the paper tray to try and make them contact the rollers better, even moving the rubber tracks towards the edge of the wheels to make their edges 'ride up' and contact the paper better.īut in the end, some sponge (visible behind the bar supporting the feed rollers) solved the problem! ( view larger)īefore I used the sponge method, moving the grippy rubber bands to the edge of the grooves on the rollers worked, proving it was a simple issue of roller clearance, but it's not ideal.

The solution: a bit of sponge (seriously).

The intake / feed-in rollers just slide around on top of the paper instead of gripping it and pulling it into the print mechanism.

The cause: a tiny spring, intended to load the paper intake rollers, is inadequately weak.

The symptom: the printer would be unable to take paper in, meaning it would sit and spin its internal rollers helplessly several times before complaining there was no paper loaded.

All components are nylon and plastic where possible, plastic is flimsy and important components like springs are small and presumably old stock - and this was ultimately the root cause of my problem. The Canon MG5750 (and printers of its ilk) are designed to a price, and that is cheap. The fix, as it turns out, is really simple!

I put up with this for a while but an attempt to print some documents evening pushed me into investigating. Soon after buying mine, the paper feed (take-up of paper from the tray into the mechanism) started to behave irregularly soon after that I ended up having to nudge each sheet of paper in to the printer, it was unable to take in paper itself. Resarch indicates it's sadly a common issue with this range of Canon printers. Unfortunately, one of the fundamental requirements of any printer - to be able to take in paper successfully - was a little lacking with this unit. Was handy at £45 (another set of genuine ink for it costs the same, go figure) but obviously I never expected it to be perfect.

#Canon mx430 series printer ws vs canon mx430 series printer Pc#

I have a cheap Canon Pixma MG5750, a Currys PC World purchase when I needed a cheap multifunction printer fast.